Under the branches/8.09 build I see a single MTD entry (and the single corresponding /dev/mtdblock0 device): I tried following the NAND erase procedure from the 433AH Wiki Page without success. If served up via TFTP the prebuilt Kamikaze AR71xx vmlinux.elf kernel will boot but panics when unable to mount a root file system. Get key - get the key from your account directly. Key / Browse - apply the purchased key here, or leave blank to install a 24h trial.
SoftID - the SoftID that was generated on the router. Install/Cancel - after selecting the router and selecting the RouterOS packages below, use this to start install. What this tutorial contain:-Installation procedure of OpenWRT on RouterBoard GL750-Installation procedure of Openflow v1.0 on RouterBoard GL750-Installation of NOX/POX/Floodlight Controller-Testing of OpenFlow enabled Network This tutorial can be downloaded from the following link. We have made a tutorial to make RouterBoard 750GL Openflow enabled. This board has a 512 MB NAND chip instead of the 64 MB one on the RB433AH (at least according to the Mikrotik spec sheets). Using either the svn trunk or branches/8.09 builds I can produce a network bootable kernel/rootfs, however I am unable to access or write OpenWRT to the NAND.
I've just acquired a RouterBoard 433UAH and was hoping to install OpenWRT.